The Last Coat CERATRIM Ceramic Powered TRIM Restorer

Description

Brought to you by The Last Coat comes our ultra-durable ceramic-based trim restorer, CeraTrim.

CeraTrim uses our popular and effective ceramic technology to bond deep into the pores of plastic trim surfaces, removing the impurities that have built up in the plastic and effectively restoring them to their original appearance.

Unlike most trim products, CeraTrim is no mere dressing or stain. It is a true ceramic coating that will give your trim surfaces superior hydrophobic and self-cleaning properties and will protect your trim for the long haul under any driving conditions while restoring them to a newer appearance.

CeraTrim can be used on all trim pieces throughout your vehicle, inside and out. It can be used on engine bay plastics to restore their appearance.

We have also used CeraTrim as a durable tire dressing, but keep in mind this is an “off-label” use and requires 2-3 coats. (please note for interior pieces it will make them glossy, so if you prefer the matte look, best to avoid CeraTrim for the interior.)

CeraTrim can be layered to get an even higher shine or deeper wet look, and even more protection. It can be re-applied over time as desired as well.

All CeraTrim Kits Come with the Following:

➡️ 1 x 8 oz. Bottle of CeraTrim

➡️ 1 x Foam Applicator (this is our preferred way of applying as seen in our videos. Some customers apply with a microfiber towel or finger mitt applicators. We like the foam applicator provided as it allows us to push CeraTrim into the pores of the surface more effectively.)

***Please note, applying CeraTrim can make surfaces very slick when wet, so when applying to running boards on your vehicle please keep this in mind as they may be quite slippery when wet.***

Brand

The Last Coat

The Last Coat

Directions for Applying CeraTrim:

1) Plastics and rubbers need to be as clean as possible before applying CeraTrim. So at the very least, we recommend washing the vehicle with a basic soap that does not contain any waxes, fillers, or conditioners. (such as The Last Soap or similar). If you are dealing with extremely dirty trim pieces, scroll down for further directions.

2) Using a soft bristle brush, thoroughly clean the texture of the plastic or rubber during the wash process.

3) Thoroughly rinse ensuring to get full soap removal.

4) Thoroughly dry the plastic or rubber and then apply CeraTrim with the included applicator. (see the video above for detailed application instructions).

5) Allow it to dwell for 5-20 minutes (depending on how faded the surface is), and then use a dry microfiber towel to buff off the excess CeraTrim.

***For extremely dirty plastics and rubber, use the following process:

1) Plastics and rubbers need to be as clean as possible before applying CeraTrim. If they are extremely dirty you will want to use a basic vehicle soap, but in addition, you will need to use a degreaser or all-purpose cleaner (APC) and a soft bristle brush to agitate down into the texture of the plastic or rubber. The soap can be used before or after APC, just make sure to use one with no waxes, fillers, or conditioners.

2) With high-pressure water, thoroughly rinse the area ensuring to get full removal of any soaps or detergents.

3) If the plastic or rubber doesn’t become fully clean, repeat the process until you achieve the deepest clean possible.

4) Thoroughly dry the plastic or rubber and then apply CeraTrim with the included applicator. (see the video above for detailed application instructions).

5) Allow it to dwell for 5-20 minutes (depending on how faded the surface is), and then use a dry microfiber towel to buff off the excess CeraTrim.